Gimbal Fluid Head Setup; Attaching The Cable Tie - PROAIM Powermatic Scissor Pro JB-SCSR-02 Assembly Manual

Gimbal Fluid Head Setup


Slide the Gimbal Fluid Head to the Jib's
mounting plate and tighten the provided
knob, as shown in the image.
NOTE: The Gimbal Fluid Head comes attached
with the Jib plate for perfect alignment of your 3
-Axis Gimbal on the Scissor Crane. If it gets
detached, you can easily mount it back.

To adjust tension on the Fluid Head, loosen or
tighten its knob per your requirement.

Now, slide the Ronin Gimbal
the Gimbal Fluid Head and tighten the knob to
lock it in its position.
NOTE: Without any camera setup this jib gets
balanced at 24kg weight. If the camera weight is
1kg, the jib is balanced with 24+3.5 = 27.5kg.

Loosen the back knob (shown in the left
image) of the Ronin Controller bracket and
slide it onto the weight rod,

Re-tighten the knob to secure the bracket.

Now, loosen the top knob of the Ronin
Controller bracket and insert the controller
into the bracket's knob and tighten it.

Attaching the Cable Tie


After completing Scissor Jib installation,
retract the jib arm.

Attach cable ties to the hole of each frame, as
shown in the image.
(Not Included) on
9