Powermatic Scissor Pro Camera Jib Crane Setup - PROAIM Powermatic Scissor Pro JB-SCSR-02 Assembly Manual

Powermatic Scissor Pro Camera Jib Crane

Insert the bolt into the hub mounting hole of
the Scissor Crane.

Now, secure the bolt using a 18mm wrench.

Place the Scissor Jib with the Hub Mounting
on top of the Jib Stand.

Insert the Locking knob on the bottom of the
Hub Mounting and tighten it.
FEATURE: You can check the leveling of the
Scissor Jib using the Bubble Leveler after which
the stand's height can be adjusted to keep
your Jib levelled.

Loosen the bolt of the Gimbal bracket and
open it.

Then, insert the two guide rods on either
side of the Crane.

After inserting the two guide rods, tighten
the bolts to secure them.

Insert the cable guide rod into the boom lock
bracket and secure the rod by tightening the
bolt.
Setup
5