Engine Oil Specifications; Checking The Engine Oil Level - Toro Reelmaster 5610-D Operator's Manual

Engine Oil Specifications

Oil Type
Use high-quality, low-ash engine oil that meets or exceeds the following service categories:
• API—CJ-4 or higher
• ACEA—E6
• JASO—DH-2
Using engine oil other than API CJ-4 or higher, ACEA E6, or JASO DH-2 may cause
the diesel particulate filter to plug or cause engine damage.
Use the following engine oil viscosity grade:
• Preferred oil: SAE 15W-40 [-17°C (above 0°F)]
• Alternate oil: SAE 10W-30 or 5W-30 (all temperatures)
Toro Premium Engine Oil is available from your authorized Toro distributor in either 15W-40
or 10W-30 viscosity grades.
Crankcase Capacity
Approximately 5.2 L (5.5 US qt) with the filter

Checking the Engine Oil Level

Note:
Check the oil when the engine is cool. If the engine is warm, wait 10 minutes before
checking.
Check the engine oil daily. If the engine-oil level is above the Full mark on the
dipstick, the engine oil may be diluted with fuel.
If the engine oil level is above the Full mark, change the engine oil.
If the oil level is at or below the Add mark on the dipstick, add oil to bring the oil level to the
Full mark. Do not overfill the engine with oil.
Be sure to keep the level of the engine oil between the upper and lower limits on the
oil gauge. Engine failure may occur because of over filling or under filling the engine
oil.
3464-486A
IMPORTANT
IMPORTANT
IMPORTANT
Page 6–14 Maintenance: Engine Maintenance