Toro Reelmaster 5610-D Operator's Manual page 68

Understanding the Diesel-Particulate Filter and
Regeneration (continued)
Note:
If you set the InfoCenter to inhibit regeneration, the InfoCenter displays an advisory
every 15 minutes while the engine requests a reset regeneration.
When you shut off the engine and start it again, the inhibit regen setting defaults to
O .
FF
1. Access the DPF Regeneration menu, and scroll down to Inhibit Regen.
2. Select the Inhibit Regen entry.
3. Change the inhibit regeneration setting from O
Preparing to Perform a Parked or Recovery Regeneration
1. Ensure that the machine has fuel in the tank for the type of regeneration you are
performing:
• Parked Regeneration: Ensure that you have 1/4 tank of fuel before performing the
parked regeneration.
• Recovery Regeneration: Ensure that you have 1/2 tank of fuel before performing
the recovery regeneration.
2. Move the machine outside to an area away from combustible materials or items that
may be damaged by heat.
3. Park the machine on a level surface, move all controls to N
and lower the cutting units.
4. Engage the parking brake and allow the engine to reach low idle speed.
Performing a Parked or Recovery Regeneration
When a parked regeneration is requested by the engine computer, follow the messages on
the InfoCenter.
The computer of the machine cancels DPF regeneration if you increase the engine
speed from low idle or release the parking brake.
1. Access the DPF Regeneration menu, and scroll down to Parked Regen or Recovery
Regen.
2. Select the Parked Regen entry or the Recovery Regen entry.
Note:
Operation: During Operation
Initiating a recovery regeneration requires you to enter the correct PIN code.
IMPORTANT
to O
FF N
IMPORTANT
Page 5–26
.
, disengage the PTO,
EUTRAL
3464-486 A