Conair TS Series User Manual page 9

AT T E N T I O N :
R e a d T h i s S o N o O n e G e t s H u r t
We design equipment with the user's safety in mind. You can avoid the potential hazards
identified on this machine by following the procedures outlined below and elsewhere in the
User Guide.
DA N G E R : S h a r p b l a d e s !
Most injuries caused by knife blades occur when the saw has been turned off.
Handle blades with care at all times.
•
Always wear cut-resistant gloves when the blade guard is open and when
handling blades.
•
Always lock out the saw before opening any guards.
•
Always wait until the saw blade has stopped completely before opening the
saw guard. (approximately five minutes)
TS Saws are equipped with several safety devices to ensure safe operation.
Never remove or disable these devices to sustain production. Operating without
these devices can cause severe injury.
•
The STOP button activates a circuit that stops the saw.
WA R N I N G : I m p r o p e r i n s t a l l a t i o n , o p e r a t i o n , o r s e r v -
i c i n g m a y r e s u l t i n e q u i p m e n t d a m a g e o r p e r s o n a l
i n j u r y.
This equipment should be installed, adjusted, and serviced by qualified techni-
cal personnel who are familiar with the construction, operation, and potential
hazards of this type of machine.
All wiring, disconnects, and fuses should be installed by qualified electrical
technicians in accordance with electrical codes in your region. Always maintain
a safe ground. Do not operate the equipment at power levels other than what is
specified on the machine serial tag and data plate.
WA R N I N G : Vo l t a g e h a z a r d
This equipment is powered by three-phase alternating current, as specified on
the machine serial tag and data plate.
A properly sized conductive ground wire from the incoming power supply must
be connected to the chassis ground terminal inside the electrical enclosure.
Improper grounding can result in severe personal injury and erratic machine
operation.
Always disconnect and lock out the incoming main power source before opening
the electrical enclosure or performing non-standard operating procedures, such
as routine maintenance. Only qualified personnel should perform troubleshooting
procedures that require access to the electrical enclosure while power is on.
I n t r o d u c t i o n l 1 - 3