P r o d u c t Q u a l i t y P r o b l e m s
Symptom
Incorrect cut length.
Table motion inconsistent.
( c o n t i n u e d )
Possible Cause
Encoder or input device problem.
Puller problem.
Counter problem.
Saw clamps not holding.
Roller ways dirty.
Rodless cylinder problem.
Solenoid problem .
Low air pressure.
Solution
Check encoder or input device.
Check puller for drive consistencies
or any belt to product slippage.
Check cut length counter.
Check rubber saw clamps for wear
and replace as necessary.
Clean roller ways.
Check and clean rodless cylinder.
Check table actuation solenoid for
proper operation.
Check main system regulator for
incoming air pressure settings.
Tr o u b l e s h o o t i n g l
6 - 7