Machine Lubrication; System Inspection - Conair TS Series User Manual

M a c h i n e L u b r i c a t i o n
The machine is supplied to you completely lubricated. After running the unit for long peri-
ods of time, this lubrication will break down and become useless. Follow this lubrication
chart for optimum performance.
Component Type of Lubricant
Table Pivot Bearings Chassis Lube
Clamp Post Slides Chassis Lube
S y s t e m I n s p e c t i o n
Although this unit was designed to require a minimum amount of maintenance, it should be
inspected periodically to insure that it remains in top operating condition.
Items to inspect are as follows:
Saw Tracks - The steel tracks that the saw motor carriages travel on, will after time, begin to
wear from the constant contact with the cam rollers. They should be visually inspected for
wear and replaced as necessary.
Saw Track Rollers - The steel cam rollers that the saw motor carriages travel on, will after
time, begin to wear from the constant contact with the saw tracks. They should be visually
inspected for wear and replaced as necessary.
Pneumatic System - Approximately once every 12 months or sooner if able, all system
pneumatic components should be visually inspected. All hoses should be checked for wear
or damage. All regulators and flow controls should be adjusted through their usable ranges
to insure proper operation.
Duration
6 - 9 months
5 - 6 months
O p e r a t i o n l 4 a - 4 3