Conair TS Series User Manual page 41

C o n t r o l Pa g e Pa r a m e t e r D e s c r i p t i o n s
( c o n t i n u e d )
Master Setup Page
Master distance:
Counts:
Master speed:
Change Count Direction:
Master source:
This data entry field adjusts the distance measured in one
revolution of the encoder. This is set at the factory and
should not require further adjustment.
This data entry field adjusts the number of counts output by
the encoder in 1 revolution of the encoder. This value is post
quadrature. This is set at the factory and should not require
further adjustment.
This display field shows the speed of the master encoder.
The values of the master distance and counts will affect the
value of the speed. The value shown, when the encoder is
turning, must be a positive value.
Press this button if the value of the master speed is negative.
This button changes the input source of the master encoder.
Two input sources are available, "Drive" and "Module".
Pressing this button will toggle between the two sources.
This is set at the factory and should not have to be changed.
( C o n t i n u e d )
O p e r a t i o n l 4 a - 1 7