Conair TS Series User Manual page 44

4 a - 2 0 l O p e r a t i o n
C o n t r o l Pa g e Pa r a m e t e r D e s c r i p t i o n s
( c o n t i n u e d )
Table Speeds HMI Reference
Speed reference select:
Hmi speed:
Advance accel:
Advance decel:
Return speed:
Return accel:
Return decel:
This button changes the source of the table speed reference.
Two input sources are available, "Encoder" and "Hmi".
Pressing this button will toggle between the two sources. When
"Hmi" is selected, the Hmi provides the speed setpoint.
This data entry field sets the table speed during the cut cycle.
Set this value to the actual extrusion line speed.
This data entry field sets the acceleration rate the table uses to
ramp up to line speed.
This data entry field sets the deceleration rate the table uses to
ramp to a stop after the cut cycle is complete.
This data entry field sets the table return speed, used when the
table returns to the home position after the cut cycle is com-
plete.
This data entry field sets the acceleration rate the table uses to
ramp up to the return speed.
This data entry field sets the deceleration rate the table uses to
ramp to a stop when returning to the home position.