Conair TS Series User Manual page 113

P r e v e n t a t i v e M a i n t e n a n c e S c h e d u l e
( c o n t i n u e d )
•
Quarterly
❒ Blow or vacuum, dust and chips from the inside the saw. Remove all dust and
chips from inside all control cabinets. Remove any excess oil from the pneumatic
enclosure.
❒ Verify that all electrical terminals are tight.
❒ Check that all air lines are in order (free of cuts or abrasions). Check the saw trav-
el rails and rollers for debris and wear.
❒ Check that the adjustable flow controls on the SAW BLADE UP cylinder is set for
a smooth downward return.
❒ Check that the adjustable flow controls on the clamp cylinder are set so that the
clamp operates quickly a slow cycle on the clamp-down will cause inaccurate
cuts in length.
❒ Check the condition of the clamp pads. If worn or damaged, replace with a
new set of pads.
❒ Check the condition of the clamp pads. If worn or damaged, replace with a
new set of pads.
❒ Check the condition of the blade. If the blade is dull, have the unit sharpened;
if it is damaged, have the blade replaced.
WA R N I N G : E l e c t r i c a l h a z a r d
Before performing maintenance or repairs on this product, disconnect and lock out
electrical power sources to prevent injury from unexpected energization or start-up.
A lockable device has been provided to isolate this product from potentially haz-
ardous electricity.
CA U T I O N : M o v i n g p a r t s
Before removing lockout devices and returning switches to the ON position, make
sure that all personnel are clear of the machine, tools have been removed and all
safety guards are reinstalled.
M a i n t e n a n c e l 5 - 5