Table of Contents
Advertisement
MAINTENANCE
UPDATING THE SOFTWARE
The mower may require periodic software updates to improve functionality. Check our website every
few months to see if a new software is available to download.
NOTE: Make sure the USB flash drive works normally and the robotic mower is switched on by
pressing the START/ON button for 1 second before updating.
NOTE: Make sure the battery indicator is green and the mower has sufficient power for updating the
software.
1. Download the robotic mower's latest software from our support website onto a blank USB flash
drive device.
2. Stop the mower and remove the safety key.
3. Turn the mower upside-down. Wear protective gloves and open the USB port rubber cap to reveal
the USB port (Fig. 23).
4. Insert the safety key. Unlock the mower if the mower is locked.
5. Press the START/ON Button for 1 second, and wait for 15 seconds until the robotic mower is
powered on completely indicated by a green battery light and beep. Insert the USB flash drive into
the USB port, then you will hear four beeps. The software is updating when three indicators (battery
indicator, unlock indicator and error indicator) are flashing.
6. After the software update is complete, you will hear continuous beeping and the battery indicator
will be green continuous.
7. Remove the USB flash drive. Replace the USB port rubber cap. To complete the software update,
restart the machine by removing and reinserting the safety key.
Fig. 23
33
Advertisement
Table of Contents
