LawnMaster VBRM601YCM Operator's Manual page 28

Mx 24v lithium-ion robotic lawn mower
Table of Contents

Advertisement

OPERATION
WARNING
Read the safety instructions carefully before you start your robotic lawn mower.
WARNING
Keep your hands and feet away from the rotating blades. Never put your hands or feet close to or
under the mower when the motor is running.
WARNING
Never use the robotic lawn mower when people, especially children, or pets, are in the cutting area.
1. Make sure the fully charged battery pack and the safety key are installed into the robotic mower
properly.
2. Put the robotic mower in the defined mowing area.
3. Unlock the mower if the mower is locked. Enter the correct security code and press the STOP
button to confirm. You will hear two beeps and the UNLOCK Indicator is green continuous. The
mower is unlocked.
4. Press the START/ON button for 1 second. The battery indicator, error indicator, ultrasonic indicator
will flash consecutively. The camera system will take approximately 15 seconds to start up. The
mower is ready to mow when the battery indicator is illuminated green continuously and the mower
beeps.
5. Select the desired cutting mode by pressing either the Auto or Spiral mode buttons for 1 second to
select the cut mode, then press the START/ON button to start mowing.
6. To stop the mower during operation, press the STOP button.
7. To turn off the mower, lift the battery compartment cover and remove the
safety key.
NOTE: If the mower is temporarily stopped by pressing the STOP button, to re-start the mower, it is
not required to enter the security code.
NOTE: If the mower is stuck or has been stopped for more than 20-25 minutes, it will automatically go
into Stand By (power off). To turn on the mower again, follow the instructions above.
CUTTING MODES
1. Auto Cutting
In Auto cutting mode, the robotic mower will mow the lawn in a random pattern.
After the robotic mower is powered on, press the Auto button for 1 second, followed by the START/ON
button. After 5 seconds of continuous running, you will hear beeps to indicate the blades have started to spin.
The robotic mower will automatically search for a suitable working area. If the robotic mower does not
find grass within 5 seconds, it will change direction and start running again in a new direction. The blades
will not spin until the mower can run for continuously for at least 5 seconds.
28

Advertisement

Table of Contents
loading

Table of Contents