Keypad Or Display Locking - LAUMAS WTAB-R Installation And User Manual

PROGRAM SELECTION: confirm  and use the arrow keys to select the desired program:
: basic program, setpoint management only.
: to be used when the loaded weighing system correspond to not loaded cells and vice versa
(product increases while weight on load cells actually decreases).
: weight remote display program with setpoint.
After confirming the choice of the program (except  and ), the user must choose its
approval state among the following possible choices:
: not approved program;
: approved program, single division (Dir. 2009/23/EC, art. 1)*;
: approved program, multi-interval (Dir. 2009/23/EC, art. 1)*;
: approved program, multiple range (Dir. 2009/23/EC, art. 1)*;
*) Contact technical assistance to request the proper manual and the correct procedures for
approval, indicating mandatory hardware code and serial number (see section
INSTRUMENT COMMISSIONING).
By confirming, the instrument is restored to default and data is erased.
If you do not have a specific manual for the newly set program, you can request it
to technical assistance.
Press ESC immediately followed by ▲ hold them down for about 5 seconds (this operation is also
possible via the MODBUS and ASCII protocols):
- : no lock.
- : keypad lock: if active, when a key is pressed the message  is displayed for 3
seconds.
- : keypad and display lock: if active, the kaypad is locked and the display shows the
instrument model (weight is not displayed); by pressing a key the display shows  for 3
seconds.

KEYPAD OR DISPLAY LOCKING

- 46 -