TOTALIZER
SELECT TOTALIZER OPERATING MODE
On WTAB instruments use MODE key in place of START/STOP key.
- : basic operations;
- : piece counter;
- : totalizer;
Select and press ENTER to confirm; select type of totalization:
- : fast manual totalization, the display shows for 1 second;
- : normal manual totalization, the display shows the number of the weighing for 1 second
and then the total weight for 1 second;
- : automatic totalization;
(default: 0): gross weight value under which the system has to go back to totalize again. Setting
0 disables this function.
(default: ): setting the weight is blocked after a totalization. To release the weight press
PRINT or close the relative input.
(default: ), only for and type of totalization: setting the weight is only
totalized if stable.
(default: ): the weight is only totalized if it has changed compared to the last
totalization. Setting the weight is always totalized.
(default: 0), only if is selected: number of automatic totalizations to be done before
partial totalized weight is printed and zero-set.
Setting 0 disables automatic totalization.
Once settings have ended, the system is ready to totalize weights; press PRINT or close the relative
input to totalize.
DISPLAY AND OPERATION
Based on selection set the total weight on scale is displayed:
- Fast manual totalization: preceded by the letter (e.g.: );
- Normal manual totalization: preceded by the letter (e.g.: );
- Automatic totalization: preceded by the letter (e.g.: );
- 39 -