Enabling Setpoint - LAUMAS WTAB-R Installation And User Manual

Press PRINT to print the number of pieces on the scale (see section PRINTING EXAMPLES).
In piece counter mode you can:
- set weight to zero for small variations (press
- set semi-automatic tare (press TARE);
- do a new sampling:
▫ WDESK – WINOX: press START for 3 seconds,  appears, press ENTER, set number of
pieces on scale and confirm with ENTER;
▫ WTAB: press MODE,  appears, press ENTER, set number of pieces on scale and
confirm with ENTER;
- WDESK – WINOX: to exit piece counter mode and return to standard operations,
press START for 3 seconds,  appears; press ESC, select the  operating
mode and confirm with ENTER. If no setpoint is enabled,you can do a new sampling
or return to standard operations also by pressing MENU.
- WTAB: to exit piece counter mode and return to standard operations, press MODE,
 appears; press ESC, select the  operating mode and confirm with ENTER.
Setpoint can be used to stop automatic loading of pieces on the weighing system.
WTAB: setpoint are always enabled.
WDESK – WINOX: proceed as follow to enable setpoint:
-  (default): setpoint disabled;
- : setpoint enabled;
Setpoint 1 and 2 switch based on number of pieces, the others always switch on weight.
After enabling the setpoint, key operations to access menus vary as follows:
- Press MENU to access setpoint settings;
- Press START for 3 seconds for new sampling or to change operating mode.
and confirm with ENTER);
0

ENABLING SETPOINT

- 38 -