Serial Connection System Example; Connecting To The Power Supply - Canon RC-IP1000 User Manual

Serial Connection System Example

Video
Monitor
SDI OUT
Monitor
Video
HDMI OUT

Connecting to the Power Supply

Power can be supplied to the device through the DC IN 12V terminal or the LAN terminal (PoE+).
DC Power Supply from the DC IN 12V Terminal
Connect an external DC power supply to the DC IN 12V
terminal (P. 84, 88) to supply power to the device.
Important
• Connect to a power supply that meets the installation site requirements (approved products and the environment) and product
specifications.
• Inrush current may cause the power supply to be insufficient and cause failure when power is turned on. Therefore, it is
recommended to use a power supply with a power capacity of two to three times the rated capacity or more.
• Make sure to turn the device off when connecting or disconnecting the connector of the DC IN 12V terminal.
Note
During PoE+ power supply, when a power supply has been connected to the DC IN 12V terminal, power is supplied from the DC IN
12V terminal after the power is turned off.
Serial Camera
Serial Camera
Control
RS-422
Video
Device
Serial Camera
Video
Video
SDI IN
Video
SDI IN
TALLY /
Control
GPIO
Control
LAN
DC Plug
23
IP Camera
Video Video
LAN
LAN
PoE+ hub
Control
Video
Switcher
Streaming
/recording
Control