Stiga P 901 PH Operator's Manual page 118

4. The starter motor turns, but the
engine fails to start
With the key switch set to "I", the
display turns on and pressing the
"START / STOP ENGINE" button
turns the starter motor, but the
engine does not start.
5. Battery warning light and digits
flash. (740 IOX, 540 IX)
"BATT" appears. (340 IX)
Attempt to start the machine;
the machine does not start, the
"Battery" warning light and "Digits"
start flashing indicating a voltage
of less than 12V.
6. Battery warning light and digits
flash. (740 IOX, 540 IX)
"BATT" appears. (340 IX)
The "Battery" warning light and
"Digits" start flashing indicating a
voltage of over than 12V.
7. Battery warning light and digits
flash and then the engine turns
off. (740 IOX, 540 IX)
"BATT" appears. (340 IX)
The "Battery" warning light and
"Digits" are flashing indicating a
voltage of over than 12V, then the
machine turns off.
8. The engine is running, the
"Battery" warning light and "Digits"
flash indicating a voltage below
12V. (740 IOX, 540 IX)
"BATT" appears. (340 IX)
9. Starting is difficult or the engine
runs erratically.
10. Weak engine performance during
work.
11. The battery indicator light remains
on even after the machine has
been running for a few minutes.
(740 IOX, 540 IX)
12. Oil warning light comes on during
work. (740 IOX, 540 IX)
13. Engine stops for no apparent
reason.
14. Irregular cutting.
Petrol tap closed.
Faulty fuel supply.
Faulty ignition.
Insufficiently charged battery.
Battery charger fuse blown.
Defect battery.
"Digits" indicates a voltage higher
than 12V; an overvoltage is present.
The battery is over the overvoltage
trip threshold.
If the condition persists:
Battery charger fuse blown.
Defect battery.
Battery charger is defective.
Carburation fault.
Forward speed too high in relation to
the cutting height.
Insufficient recharging.
Engine lubrication problems.
- Fuel has run out.
- Try restarting the engine.
Cutting means sharpening is
reduced.
High advancing speed in relation to
the height of the grass to be cut.
The cutting means assembly is full
of grass.
EN - 9
Open the petrol tap.
- Check the level in the tank.
- Check the fuel filter.
- Check that the spark plug cap is
securely fitted.
- Check that the electrodes are clean
and have the correct gap.
Loading the battery.
Replace the fuse.
Replace the battery.
Contact an Authorised Service Centre.
Contact an Authorised Service Centre.
Replace the fuse.
Replace the battery.
Contact an Authorised Service Centre.
Clean or replace the air filter.
Reduce advancing speed and/or
increase the cutting height.
Contact an Authorised Service Centre.
- Switch off the machine immediately.
- Fill up the oil level
(If this problem persists, contact the
Authorised Service Centre).
Top up the fuel (if the problem persists,
contact an authorised service centre).
Check the tyre pressure.
Contact an Authorised Service Centre.
Reduce advancing speed and/or
increase the cutting height.
- Wait for the grass to dry.
- Clean the cutting means assembly.