Calibration; Lwd Communication; Figure 5: Main Menu - Setup; Figure 6: Setup Menu - Load Weigher - Smartrise C4 Manual

Load Weighing Device

Calibration

The LWD must be calibrated after connecting the LWD and sensors.

LWD Communication

Depending on the location of the LWD, the device communicates to the controller serially to
the MR board or CT board.
The following procedure describes how to set the Load Weighing Device communication.
1. Press the right button to access the Main Menu.
2. From the MAIN MENU, scroll and select Setup.
3. From the SETUP menu, scroll and select Load Weigher.
4. From the LOAD WEIGHER SETUP menu, scroll and select Type Select.
Page 4
Figure 5: MAIN MENU – Setup
Figure 6: SETUP Menu – Load Weigher
Figure 7: LOAD WEIGHER SETUP Menu – Type Select
©2021 Smartrise Engineering, Inc. All Rights Reserved September 29,2021