Long-Term Storage; Before Storage; During Storage; After Storage - Komatsu ecot3 GALEO HM300-2 Operation And Maintenance Manual

LONG-TERM STORAGE

LONG-TERM STORAGE

BEFORE STORAGE

When keeping in long-term storage (more than one month), store as follows.
After every part is washed and dried, house the machine in a dry building. Never leave it outdoors.
In case it is indispensable to leave it outdoors, park the machine on the flat ground and cover it with canvas etc.
Completely fill the fuel tank. This prevents moisture from collecting.
Lubricate and change the oil before storage.
Coat the exposed portion of the hydraulic cylinder piston rod with grease.
Disconnect the negative terminals of the battery and cover it or remove it from the machine and store it separately.
Apply the parking brake.
Set the tire inflation pressure for each tire to within the range of the specified inflation pressure for the type of tire.
Push the retarder control lever forward to the OFF position.
Place the gear shift lever at the N position and turn the starting switch OFF.
To prevent corrosion, be sure to fill the cooling system with Supercoolant (AF-NAC) or permanent type antifreeze
(density between 30% and 68%).

DURING STORAGE

If it is necessary to perform the rust-prevention operation while the machine is indoors, open the doors and windows to improve
ventilation and prevent gas poisoning.
During the storage period, operate the machine once a month to prevent loss of the oil film at the lubricated parts.
At the same time, charge the battery.
Before operating the work equipment, wipe off all the grease from hydraulic piston rods.

AFTER STORAGE

NOTICE
If the machine has been stored without carrying out the monthly rust-prevention operation, consult your Komatsu distributor
before using it.
When using the machine after long-term storage, do as follows before using it.
Wipe off the grease from the hydraulic cylinder rods.
Add oil and grease at all lubrication points.
When the machine is stored for a long period, moisture in the air will mix with the oil. Check the oil before and after
starting the engine. If there is water in the oil, change all the oil.

PRECAUTIONS BEFORE TRAVELING AFTER LONG-TERM STORAGE

1. Check all the oil and water levels before traveling.
2. When traveling after long-term storage, travel forward at a speed of 10 to 15 km/h (6.2 to 9.3 MPH) for 5 minutes
or 1 km to run the machine in, then change to normal travel.
3 - 124
WARNING
https://www.besttruckmanuals.com/
OPERATION