Table of Contents
Advertisement
OPERATION
ADJUSTING MIRROR
Be sure to adjust the mirrors before starting work. If they are not adjusted properly, you cannot secure the visibility and may be
injured or may injure someone seriously.
Loosen mirror securing bolt (1), screw (2) and nut (3) and adjust the
mirror position the way it assures the best view from the operator's
seat.
Adjust the position and angle of each mirror so that it reflects a
sight 200 mm above the ground and up to 1500 mm. In the
adjustment, make sure that part of the dump truck's image also
comes into view.
View Range
Mirror A: Shaded area (A) should be in view.
Mirror B: Shaded area (B) should be in view.
Mirror C: Shaded area (C) should be in view.
Mirror D: Shaded area (D) should be in view.
Mirror E: Shaded area (E), tire's ground contact point (G') and
ground (G'') should be in view.
Mirror F: Shaded area (F) should be in view.
Mirror G: Shaded area (G), tire's ground contact point (G') and
ground (G'') should be in view.
Rear Monitor (optional): Shaded area (H) should be in view.
WARNING
https://www.besttruckmanuals.com/
OPERATION
3 - 83
Advertisement
Chapters
Table of Contents
