Table of Contents
Advertisement
3. PROGRAM AND START-UP INSTRUCTIONS
1. Program description
A. Normal mode
B. Three countdown modes: Time countdown, Distance countdown and Calorie countdown.
C. 15 setting procedures: P01~P15
D. FAT measuring function
2. Start-up instructions
Place the safety lock on the switch position of the safety lock on the panel, the console will be fully displayed, and
a buzzer will sound. It will then be on standby state.
3. Normal Mode
1.1 In the standby state, press the "START" key. The display enters the normal mode, a buzzer will beep, and the
window displays will countdown from 3, after 3 the treadmill will begin moving. Time starts from "0:00" and other
windows start from zero, and the speed starts from 1.0kph.
1.2 Press the "STOP" key during operation to pause workout, and the distance, calories and time will remain the
same values. The speed window will decrease with a change of 0.1, and the window will display "PAU" after the
speed changes to 0.0.
1.3 Press the "STOP" key in the during PAU state to stop running. This will return the treadmill to standby state and
reset all data to zero.
4. Target (Countdown) Mode
There are three target countdown modes.
A. Press the "Mode" key in standby mode to enter the Time countdown mode. In the setting state, the time window
displays the initial time and will flash. Press the Speed +/- key to set the time.
B. In the Time countdown MODE, press the "Mode key" to enter the Distance countdown mode, the "distance" window
will flash "1.00" every second. When the Distance icon lights up, press the Speed +/- key to set the moving distance.
C. In the Distance countdown MODE, press the "Mode key" to enter the Calorie countdown mode. The "Calories"
window will flash "50.0" every second. When the Calorie ICON lights up, press the Speed +/- key to set the
movement distance.
D. Select one of the three countdown modes, press the start key after setting is completed. The display will
countdown from 3. You can press the "Speed +" and "Speed -" keys to adjust the speed in the movement state.
4. OPERATION OF TARGET MODE:
A. Press the start button to initiate the countdown, and the motor will commence running at its lowest initial
speed.
B. Adjust the speed by using the speed addition and subtraction keys.
C. Stop the motor by pressing the stop key while it is running.
D. Quickly set the speed marked by the key by pressing the speed shortcut key.
E. In case of an urgent need to stop the motor, pull off the safety lock. The display will show "-", and a buzzer will
sound bi.
F. When the set target decreases to zero, the speed will gradually slow down until it stops, accompanied by a short
bi every second. After 15 seconds, the window will flash, displaying "END," and then return to standby mode in 3
seconds.
ASSEMBLY INSTRUCTIONS |
13
Advertisement
Table of Contents
