Setting Delay Time - Kenwood TM-732A Instruction Manual

2-5. Setting Delay Time
The DTSS signal is not transmitted immediately after
you press the PTT switch. A programmable delay
time has been incorporated to allow the DTSS signal
to be passed by repeaters with slow response times.
You can select a delay time of 350 mS or 550 mS.
When operating simplex mode a delay of 250mS will
automatically be selected for you. No other choice is
available in this mode, even though you may have
selected a different delay.
In modes other than simplex you may select between
the remaining delay periods (350 mS or 550 mS).
The delay time is the same for both bands.
PTT ON PTT OFF
v v
ol
L__code
Delay time (350mS or 550mS)
OChanging the delay time to 550 ms.
1. Turn the POWER switch off.
2. Hold down the SHIFT/DTSS key, then press the
POWER switch.
3. 350 (initial setting) appears in the frequency display
for the operation band. Select 550 by turning the
tuning control.
4. To return to the normal frequency display wait 10
seconds for automatic return, or press any key.
63