Kenwood TM-732A Instruction Manual page 57

DTMF key Control function
Cc Toturn Repeater Cross-Band on
D To turn the Repeater Cross-Band off
* Same as DOWN key
# Same as UP key
CAUTION :
Examples
CO Set the frequency to 145.320 MHz.
Enter " A ""4(K, P type only) "*5""° 3" 2™ 0"
with the DTMF keys.
OSelect to memory channel mode
Press DTMF key 9.
The transceiver enters the memory channel mode.
Select a memory channel by pressing the DTMF
"#" key (same as the UP key) and " * " (same
as the DOWN key).
O Select the tone frequency.
Press DTMF key "B"" A", then press the
approprateCH. NO. key as given in the table on page
59.
To set 100.0 Hz for the tone frequency, enter "1"
=o,
The Repeater Cross-Band mode can be turned ON/OFF
with external DTMF commands as follows. This will allow
you to remotely change the operating frequency of the
controlled band.
© Toturn Repeater Cross-Band on
41. Access the TM-732A by sending "A", the DTSS
code, and then "#".
2. Then send the C command.
3. Then send the "A" and " #" command.
OTo turn the Repeater Cross-Band off
1. Send "A", the DTSS code, and then " #".
2. Then send the "D." command.
To cance! the function:
1. Transmit "A '" #" from the remote transceiver to
return to step 4.
2. Hold down the F key, then press the MHz key within
10 seconds. (Lock release) (On the local unit)
3. Turn the POWER switch off.
4. Hold down the C. SEL key, and press the POWER
switch.
57