Kenwood TM-732A Instruction Manual page 75

Symptom
Probable cause
Corrective action
DTSS or paging does not
work through the repeater.
The repeater ID overlaps with data,
so the remote station cannot receive
the code properly.
Release the PTT, confirm that no ID is
transmitted, and then press PTT again.
DTSS or paging does not
work.
The remote transceiver is in the
battery save mode.
Press PTT again.
The S meter pointer stops
midway, and only strong
signals can be received.
S meter squelch is set.
Cancel S meter squelch.
The receive tone breaks
up.
The SQL control has been turned
too far clockwise.
Select a channel in which there is no
signal, and set the control to the position
where the noise disappears.
Squelch turns on
whenever a signal comes
in, even if paging is set.
Signaling squelch has been
canceled.
Turn the POWER switch off, hold down
the VOL control for the band for which
paging is set, then press the POWER
switch.
The following formula can be used to help determine if a particular frequency combination will cause
interference/birdies.
(VHF band UHF receive frequency - 45.05) x 2 - (UHF band receive frequency - 58.525) x 2 = 45.05 MHz
75