Vox Delay Time; Transmit Inhibit While Receiving - Kenwood NX-P500 User Manual

VOX DELAY TIME

If the transceiver returns to receive mode too quickly after you stop speaking, the
end of your message may not be transmitted. To avoid this, select an appropriate
delay time that allows your entire message to be transmitted. However, do not
make the delay overly long.
1
Enter the Setting mode {p.37}.
2
Press the
3
Press the Menu button then press the
value.
0.1/ 0.3/
/ /
0.5/ 1.0/
/ / /
1.5/ 3.0
4
Press the Menu button to confirm the selection, then press the PTT switch or
the Side button to return to the operation mode.

TRANSMIT INHIBIT WHILE RECEIVING

While using VOX, you can set the transceiver to detect when the channel is in use
(in place of using the Monitor function). With this function turned on, VOX will not
allow you to transmit while the channel is being used. You can transmit only when
the channel is free.
1
Enter the Setting mode {p.37}.
2
Press the
3
Press the Menu button then press the
value.
4
Press the Menu button to confirm the selection, then press the PTT switch or
the Side button to return to the operation mode.
or button to select "
During transmission, from 0.1 seconds to 3.0 seconds VOX
transmission will continue if there is voice input reaching
microphone sensitivity that operates VOX during the selected
time.
or button to select "
OFF Even if the channel is used, VOX will allow transmission.
While the channel is being used, VOX will not allow you to
ON
transmit.
".
or button to select your desired
".
or button to select your desired
60