Kenwood TM-732A Instruction Manual page 2

Thank you for purchasing this new transceiver.
IMPORTANT:
Please read this instruction manual carefully before
placing your transceiver in service.
CAUTION:
Long transmission or extended operation in the HI power
mode might cause the rear of this transceiver to get
warm.
Do not place the transceiver where the heat sink (rear
panel) might come in contact with plastic or vinyl
surfaces.
NOTE: If disregarded, inconvenience only, no
risk of equipment damage or personal
injury.
CAUTION: Equipment damage may occur, but not
personal injury.
Save this instruction manual.
This instruction Manual covers the following models.
TM-732A: 144/440MHz FM DUAL BANDER
(U.S.A. , CANADA version)
TM-732A: 144/430MHz FM DUAL BANDER
(General markets)
TM-732E: 144/430MHz FM DUAL BANDER
(European markets)
Notice to the user:
One or more of the following statements may be
applicable to this equipment.
2
FCC WARNING
This equipment generates or uses radio frequency
energy. Changes or modifications to this equipment
may cause harmful interference unless the
modifications are expressly approved in the instruction
manual. The user could lose the authority to operate
this equipment if an unauthorized change or
modification is made.
Information to the digital device user required by the
FCC:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can generate radio frequency
energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee
that the interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can
be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
-- increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
-- Consult the dealer for technical assistance.