Kenwood TM-732A Instruction Manual page 12

BH INSTALLATION INSTRUCTIONS
1. Mobile Installations
1-1. Mounting Bracket
Notes
. When installing the transceiver consider ease of
operation and safety when selecting the location
for the mounting bracket.
. Install the bracket securely so that it will not come
off due to vibration.
=
i)
1-2. Battery Connections
Connect the power cable directly to the battery
terminals. Use of the cigarette lighter socket will lead
to poor connection, and will result in poor
performance. Pay close attention to the polarity of the
cables when connecting them to the battery.
=
. Install the bracket using the supplied flat washers
and self tapping screws (4 pcs. each).
. Attach the transceiver loosely using the SEMS
screws (4 pcs.).
. Adjust the viewing angle of the bracket to the
desired position .
. Hold the transceiver in place and tighten the 4
SEMS screws using the supplied wrench.
- oO N
Flat washer rf ~
Tapping screw
screw
Cautions
1. Before installing the power cable, be sure to
remove the negative lead from the battery for
safety.
2. After installation and wiring, be sure to double
check for correct installation before reconnecting
the negative lead to the battery terminal.
3. If the fuse opens, be sure to check that each
conductor has not been damaged by short
circuiting, etc. Then replace with a new fuse of the
same rating.
4. After completing the wiring, wrap the fuse holder
with heat resistant tape to protect against heat and
moisture.
5. Do not remove the fuse even if the power cable is
too long.
Caution
Leave enough space around the fan on the rear panel
for good ventilation.
12