Programmable Band Scan; Memory Channel Scan - Kenwood TM-732A Instruction Manual

2. Programmable Band Scan
The lower- and upper frequency limits are set in
advance for each band.
@ Lower and the Upper Scan Limit Entry
4. Hold down the F key, then press the MHz key.
L appears on the memory channel display.
2. Select the lower frequency limit with the tuning
control, then press the MR key.
U appears on the memory channel display.
3. Select the upper frequency limit with the tuning
control, then press the MR key.
To display the upper and lower frequency limit :
1. Hold down the F key, then press the VFO key.
The lower frequency limit is displayed.
2. Turn the tuning control until a click is heard.
The upper frequency limit is displayed.
The normal frequency display will return after
pressing any key or after a 10 second delay.
Md Operation
. Press the BAND SEL key to select the desired band.
Z Adjust the SQL control to the threshold point.
3. Select a frequency between the two programmed
scan limits.
4. Press the VFO key for longer than 1 second. The
MHz indicator will begin flashing as a visual reminder
the transceiver is scanning.
Press the PTT switch or any other key to stop
scanning.
a
3. Memory Channel Scan
1. Press the BAND SEL key to select the desired band.
2. Adjust the SQL control to the threshold point.
3. Press the MR key for longer than 1 second to initiate
memory scan of the band.
© >) 22
waned 2 | 20
L wOOOO |
6
. Scan will begin in an upwards direction. You can
reverse the direction of scan by turning the Tuning
control or pressing the microphone UP/DWN keys.
. Scan will stop on a busy channel, i.e. a station that is
strong enough to open the squelch and turn on the
BUSY indicator.
NOTE
1. Only those memory channels that have data
entered, and that have not been locked out it will
be scanned.
2. Scan does not start unless there are 2 channels
that have data entered.
4