Manually Setting The Printer's Ip Address - Xerox Phaser 7400 User Manual

Manually Setting the Printer's IP Address

Note: Verify that your computer has a properly configured IP address for your network.
Contact your network administrator for more information.
If you are on a network without a DNS server, or in an environment where the network
administrator assigns printer IP addresses, you can use this method to manually set the IP
address. Manually setting the IP address overrides DHCP and AutoIP. Alternatively, if you are
in a small office with a single PC and use a dialup modem connection, you can manually set
the IP address.
1.
On the control panel, select
2. Connection
Select
3. Select Network Setup, and then press the OK button.
4. TCP/IP Setup, and then press the OK button.
Select
5. Select DHCP/BOOTP, and then press the OK button to select Off.
6. Select TCP/IP Address, and then press the OK button.
7.
Enter the printer's IP address, and then press the OK button.
Printer Setup, and then press the OK button.
Setup, and then press the OK button.
Phaser® 7400 Color Printer
2-8
Configuring the Network Address