Manually Setting The Printer's Ip Address - Xerox Phaser 6280 User Manual

Manually Setting the Printer's IP Address

Note:
Contact your network administrator for more information.
If you are on a network without a DHCP server, or in an environment where the network
administrator assigns printer IP addresses, you can use this method to manually set the IP
address. Manually setting the IP address overrides DHCP and AutoIP. Alternatively, if you
are in a small office with a single PC and use a dialup modem connection, you can
manually set the IP address.
Information Required for Manual IP Addressing
Information
Internet Protocol (IP) address of the printer
Network Mask
Default Router/Gateway address
Downloaded From ManualsPrinter.com Manuals
Verify that your computer has a properly configured IP address for your network.
Configuring the Network Address
Comments
Format is xxx.xxx.xxx.xxx, where xxx represents a
decimal number from 0–255.
Get this information from your network
administrator.
Router address is required to communicate with the
host device from anywhere other than the local
network segment.
Phaser® 6280 Printer
37