Manually Setting The Printer's Ip Address - Xerox Phaser 6360 User Manual

Manually Setting the Printer's IP Address

Note:
Contact your network administrator for more information.
If you are on a network without a DHCP server, or in an environment where the network
administrator assigns printer IP addresses, you can use this method to manually set the IP
address. Manually setting the IP address overrides DHCP and AutoIP. Alternatively, if you are
in a small office with a single PC and use a dialup modem connection, you can manually set
the IP address.
Information Required for Manual IP Addressing
Information
Internet Protocol (IP) address of the printer
Network Mask
Default Router/Gateway address
To manually set the IP address:
1.
2.
3.
4.
5.
6.
7.
Downloaded From ManualsPrinter.com Manuals
Verify that your computer has a properly configured IP address for your network.
On the control panel, select
Select
Connection Setup
Select , and then press the OK button.
Network Setup
Select , and then press the OK button.
TCP/IP Setup
Select , and then press the OK button to select
DHCP/BOOTP
Select , and then press the OK button.
TCP/IP Address
Enter the printer's IP address, and then press the OK button.
Phaser® 6360 Color Laser Printer
Comments
Format is xxx.xxx.xxx.xxx, where xxx represents
a decimal number from 0–255.
If you are unsure, leave this blank; the printer
chooses an appropriate mask.
Router address is required to communicate with
the host device from anywhere other than the
local network segment.
, and then press the OK button.
Printer Setup
, and then press the OK button.
2-7
Configuring the Network Address
.
Off