Stapling Output - Xerox Phaser 7400 User Manual

Stapling Output

If your printer has a finisher, you can have each set of copies stapled. Stapled output is
delivered to the finisher output tray. Stapling is supported for the following paper sizes and
weights:
■ Paper up to 305 mm (12 in.) wide
■ Paper within the weight range 64–120 g/m
Stapling is not supported for specialty media including envelopes, transparencies, glossy
paper, and labels.
Stapling Options
The following stapling options are available from the printer driver:
■ None (Factory default): Print copies are not stapled.
■ Front: Inserts one staple in each set of copies. Up to 50 sheets can be stapled.
■ Rear: Inserts one staple in each set of copies. Up to 50 sheets can be stapled.
Dual: Inserts two staples in each set of copies. Up to 50 sheets can be stapled. The stapled
■
edge must be at least 148 mm (5.83 in.) long.
■ Saddle: Staples and folds each set of copies along the center line. Up to 10 sheets can be
folded and stapled.
The Booklet option in the printer driver can be used with the Saddle stapling option to
print, staple, and fold the sheets into a booklet. For information about printer driver
options, see the Advanced Features Guide at www.xerox.com/office/7400support.
Front, Rear, and Dual stapled copies are sent to the finisher upper output tray. Saddle stapled
copies are sent to the finisher lower output tray.
Staple Orientation
The sample image in the printer driver shows the location of the staples, which changes
depending on the orientation of the page and the paper feed direction (long-edge or short-edge
feed).
See also:
Loading Paper on page 3-8
2
(17–31 lb. Bond, 24–43 lb. Cover)
Phaser® 7400 Color Printer
3-53
Choosing Output Options