Table of Contents
Advertisement
DRAWBAR DIRECTION
Normally, pulling a Drawbar out will increase the volume level of a sound or the amount of a Parameter,
while pushing a Drawbar in will decrease a volume or Parameter amount. However, when the Ens or Syn
Instrument Types are selected, the direction of the Drawbars can be changed so that volumes or Parameter
values can be increased by pushing a Drawbar in and pulling a Drawbar out will decrease volumes or
values.
NOTE: This Parameter does not affect the B-3, Vx, Farf or Ace Instrument Types.
1.
With the instrument "ON," press the SYSTEM/RECORD button. The LEDs on the instrument
will start flashing.
3.
Press the CHORUS/OVERDRIVE button. The LED of the CHORUS/OVERDRIVE button will stop
flashing and light continuously. The other LEDs will continue to flash.
3.
Use the bottom two notes of the keyboard to select the option you want. The data chart below
shows the options you may select.
Key
0
Normal operation (Drawbars increase values when pulled out and decrease values when pushed in).
1*
Reverse operation (Drawbars increase values when pushed in and decrease values when pulled out).
Also, the V-3 LED of the VIBRATO & CHORUS Mode will light.
4.
After you have made your selection, press the SYSTEM button to turn it "OFF" (LED not lit).
The Drawbars will now change sounds or Parameters according to your selection.
DRAWBAR DIRECTION
Function
*default setting
Special Performance Features
HA<O>
M-solo Reference Guide
51
Advertisement
Table of Contents
