Table of Contents
Advertisement
42
Patches
Editing a Factory Patch
In addition to creating and Recording new Patches, you can also make changes to an existing Patch and
Record your changes as a new User Patch. This is useful if a Patch already contains most of what you want
and you need make only a few changes to it to achieve your desired result.
TRY THIS:
1.
Select one of the three Factory Patches.
2.
Make whatever changes to the Patch you wish.
3.
When you have completed your edits, Press and Hold the SYSTEM [RECORD] button.
4.
While holding the SYSTEM [RECORD] button, press one of the three PATCH buttons. You will
see the LED of the PATCH button you selected flash "ON" and "OFF" for approximately 2
seconds.
After the LED stops flashing, your new Patch has been Recorded.
NOTE: You can make changes using the front panel controls when any one of the three Patches is
active (PATCH button LED lit). If you do so and you want to recall the Patch settings, press the active
PATCH button again. The settings contained in that Patch will be recalled.
NOTE: You can also make changes while a Patch is active and press one of the other Patch buttons;
however, your changes will not be remembered unless you Record them into one of the three Patch
buttons.
Restoring Patches
If you have made changes to a Patch or Patches and you want to restore the factory Patch settings, you can
do so by doing the RESTORING FACTORY SETTINGS procedure. This procedure is described in the
SPECIAL PERFORMANCE FEATURES chapter of this Guide on page 53.
HA<O>
M-solo Reference Guide
Advertisement
Table of Contents
