Huawei LUNA2000-5-S0 User Manual page 18

LUNA2000-(5-30)-S0
User Manual
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
Issue 15 (2024-01-12)
When installing the ESS in a garage, keep it clear of the drive path. It is
recommended that the ESS be mounted on the wall higher than the bumper
to prevent collision.
Do not install the ESS in places that are enclosed, unventilated, without
proper fire fighting facilities, or difficult for firefighters to access. Do not place
flammable or explosive materials around the ESS. It is recommended that the
ESS be mounted on a wall to avoid contact with water.
Install the ESS in a sheltered place or install an awning over it to avoid direct
sunlight or rain.
For areas prone to natural disasters such as floods, debris flows, earthquakes,
and typhoons, take corresponding precautions for installation.
Do not install the ESS in an easily accessible position because the temperature
of the enclosure and heat sink is high when the ESS is running.
Do not install the ESS on a moving object, such as ship, train, or car.
Ensure that the equipment is stored in a clean, dry, and well ventilated area
with proper temperature and humidity and is protected from dust and
condensation.
Keep the installation and operating environments of the equipment within the
allowed ranges. Otherwise, its performance and safety will be compromised.
Do not install, use, or operate outdoor equipment and cables (including but
not limited to moving equipment, operating equipment and cables, inserting
connectors to or removing connectors from signal ports connected to outdoor
facilities, working at heights, performing outdoor installation, and opening
doors) in harsh weather conditions such as lightning, rain, snow, and level 6
or stronger wind.
Do not install the equipment in an environment with direct sunlight, dust,
smoke, volatile or corrosive gases, infrared and other radiations, organic
solvents, or salty air.
Do not install the equipment in an environment with conductive metal or
magnetic dust.
Do not install the equipment in an area conducive to the growth of
microorganisms such as fungus or mildew.
Do not install the equipment in an area with strong vibration, noise, or
electromagnetic interference.
Ensure that the site complies with local laws, regulations, and related
standards.
Ensure that the ground in the installation environment is solid, free from
spongy or soft soil, and not prone to subsidence. The site must not be located
in a low-lying land prone to water or snow accumulation, and the horizontal
level of the site must be above the highest water level of that area in history.
Do not install the equipment in a position that may be submerged in water.
If the equipment is installed in a place with abundant vegetation, in addition
to routine weeding, harden the ground underneath the equipment using
cement or gravel.
Do not install the equipment outdoors in salt-affected areas because it may
be corroded. A salt-affected area refers to the region within 500 m of the
coast or prone to sea breeze. Regions prone to sea breeze vary with weather
Copyright © Huawei Digital Power Technologies Co., Ltd.
1 Safety Information
9