Clearing A Binder Tape Fault - Xerox DocuTech 6100 Operator's Manual

Sheets are spilling out
of the top tray

Clearing a binder tape fault

DocuTech 61xx Operator Guide
Table 6-3. Resolving a finisher problem
The capacity of the top tray is 500 sheets of substance 20 (75 g/m2) or 2
inches (51 mm) in height. When intermixed stock or paper heavier than
substance 20 (75 g/m2) is being run, the capacity of the top tray is
reduced.
500 sheets of substance 20 (75 g/m2) is equal to approximately:
415 sheets of substance 24 (90 g/m2)
310 sheets of substance 32 (120 g/m2)
225 sheets of substance 110 (200 g/m2)
If using any paper heavier than substance 20 (75 g/m2) or intermixed stock
of different weights, unload the top tray before the count in the tray reaches
its capacity limit.
Refer to the satisfaction guides in the "Technical information" chapter.
Perform the following to clear a binder tape fault.
1. Open the finisher doors.
2. Open the top cover.
The binder tape adhesive is hot, approximately 425°F
(218°C). Allow the binder to cool for 5 minutes with the
finisher doors and top cover open before touching the
binder tape.
3. Follow the instructions on the screen to determine the area
(17 or 18) that should be cleared.
4. If area 17 is displayed and the binder tape is present, stop
and follow the WARNING. Remove the binder tape and
paper. Proceed to step 6.
5. If area 17 is displayed and the binder tape is not present,
follow the instructions on the area 17 label and remove all
paper.
6. Ensure that area 17 is clear of all binder tape adhesive. If the
area is not clear, clean the binder using the procedure,
"Cleaning the binder," in this guide.
WARNING
Problem solving
6-9