Issues Remaining From Previous Release; Cq#45919 Tray Programming Reverts To Default Settings; Cq#45544 Build Job; Cq#43471 Skewed Inserts With Xerox Tape Binder - Xerox Nuvera 100 Hints And Tips Manual

Release Issues Xerox Nuvera

Issues remaining from previous release

CQ#45919 Tray Programming Reverts to Default Settings

Description
When 'After Every Tray Cycle' tray confirmation is enabled, and a tray is cycled, all tray
programming, except for Stock Size, in the pop-up confirmation window is set to default.
Workaround
If you are using named stock or stock weight different than the queue default weight then it is
recommended that you set [System Preferences -> Stocks and Trays -> Tray Confirmation] to
'None'. If you do not, then each time the tray confirmation pop-up window opens all the
values will be set to the queue default values.

CQ#45544 Build Job

Description
11x17 and 8 1/2x14 build jobs are printing with second segment as 8.5x11 instead of 11x17.
Workaround
When using Build Job, please leave the paper selection set to APS before entering Build Job.
Once you are in Build Job you can change the paper selection to any stock you wish. You also
can leave it set to APS.

CQ#43471 Skewed Inserts with Xerox Tape Binder

Description
Books printed on 60gsm paper that have heavy (90gsm and higher) inserts can cause last
several pages in the book to be skewed.
Workaround
Recommend using inserts less than 90gsm when body is 60gsm.

CQ#43522 Annotation-1

Description
Do not use Annotation when feeding from the short edge feed tray and selecting the 180
degree rotate. The annotation will be upside-down.
Workaround
None.
3-2 Hints and Tips Guide