Xerox DocuTech 6100 Operator's Manual page 129

Xerox docutech 6100: operator guide
Hide thumbs Also See for DocuTech 6100:
Table of Contents

Advertisement

DocuTech 61xx Operator Guide
Table 7-10. Satisfaction guide for various stocks
Stock type
Preprinted stock
High speed
transparencies with white
stripe
Label stock
Letterhead (preprinted)
Textured paper
Window stock
Xerox Carbonless
Do not use the following stocks:
Multipart forms
Stocks outside of the recommended size and weight ranges
Instructions for use
Preprinted forms must be made up of ink that has
the following characteristics:
Can withstand temperatures up to 400°F
(204°C)
Can withstand pressure of 140 psi at the
above temperature
Can withstand the above conditions for 25
milliseconds
Load the stock with the stripe to the right in trays
1 and 2.
Load the stock face up into trays 1 and 2; face
down into trays 3, 4, and 5.
Do not select 2-sided prints.
Load the paper into trays 3, 4, and 5; side 1 with
the printed side down, top edge to the front of the
tray.
Load the paper into trays 1 and 2; side 1 up with
the top edge to the front of the tray.
Do not use freshly preprinted paper in trays 1 and
2.
Heavily textured paper may produce prints with a
ragged character appearance or deletions. To
test, run a proof print.
Run if the window is 2.2 to 4 inches (57 to 102
mm) from the top edge of the paper and at least 1
inch (25.4 mm) from each side of the paper.
Run only as the first page or a front cover to
avoid finisher bin jams.
Load the window stock face-up into a tray (tray 1
or 2 is recommended) with the top edge toward
the front of the tray.
If running plastic-covered window stock, there
may be some distortion. To test, run a proof copy.
Xerox Carbonless Paper is recommended.
Technical information
7-13

Advertisement

Table of Contents
loading

Table of Contents