Simple Network Management Protocol (Snmp) Configuration - Xerox DocuPrint 115 System Manual

Gateway Configuration

Simple Network Management Protocol (SNMP) Configuration

2-2
7. The configuration utility exits.
8. When complete, close the Terminal window and select
System, Restart on the DocuSP user interface.
To configure the SNMP configuration, follow the instructions for
configuring the HTTP Gateway in the previous section.
SNMP provides you with the status of network devices. If you are
familiar with SNMP manager, you may want to configure the
SNMP gateway using gwConfig and the information that follows.
NOTE: SNMP requires a standard FlexLm license. The System
Administrator must enable SNMP in License Manager.
Xerox recommends the following third–party SNMP software
mangers:
• IBM Network Printer Manager (NT)
• TNG Unicenter (NT)
• HP OpenView (UNIX, NT)
• Xerox CentreWare (UNIX, NT)
NOTE: The SNMP manager (HP OpenView) may have a
number of requests into DocuSP for information. Some of the
requested information may not be a supported data set on
DocuSP. Therefore, the SNMP client/manager displays "no
value...etc".
NOTE: You can have more than one SNMP manager running at
the same time.
System Guide
Common Controller