Audi A3 1997 Service Manual page 40

Audi A3 1997 ➤
Electrical system Self-diagnosis - Edition 02.2002
◆ Dash panel insert replacement => Page
- Use moving bar to change adaption value =>"A - Changing adaption value with moving bar", Page
Or
- Change adaption value by means of direct entry => "B - Changing adaption value by means of direct entry",
Page 24 .
- Enter 5-digit adaption value. Use "0" to fill up empty spaces.
Example:
Specification: 240 days
Keypad entry: 00024
Note:
Fault message "Function unknown or cannot be implemented at present" appears if an implausible value is
entered.
-> Display on VAS 5051 following adaption:
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
Example:
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Channel 7
Value 24 saved
- Terminate function "10 - Adaption" by touching ◂ key.
Adaption channel 09 - Entering mileage after replacing dash panel insert
This function can be used to enter mileage count on dash panel insert replacement.
Notes:
◆ Adaption is only possible for dash panel inserts with a mileage of up to max. 100 km.
◆ Adaption can only be performed once for a given dash panel insert.
◆ It is only possible to enter a higher adaption value (greater than 100 km).
◆ Confirmed incorrect entries cannot be corrected. Dash panel insert must then be replaced.
◆ Adaption must be made in kilometres even in countries where distances are measured in miles. This involves
converting adaption value from miles to kilometres.
34
01 - Self-diagnosis
44 .
22 .