Installing The Floppy Disk Drive (Fdd) And Slim Cd-Rom Drive - Advantech PPC-153T User Manual

4.6 Installing the Floppy Disk Drive (FDD)
and Slim CD-ROM Drive
Installation of a floppy disk drive and slim CD-ROM drive is similar
to that for a hard disk drive. The metal plate for holding the FDD and
the CD-ROM support bracket are on the left side of the shielding case.
The 26-pin and 40-pin yellow FPC cables are for connecting the FDD
and CD-ROM respectively. Only 3.5" floppy disk drives (720 KB and
1.44 MB) and slim CD-ROM drives can be attached to the metal plate
and CD-ROM support bracket.
1. Detach and remove the plastic rear cover and side panel.
2. There is a metal plate which holds the FDD and slim CD-ROM
3. Push the metal plate toward the outside of the unit. This will free
4. Slide the CD-ROM support bracket toward the outside of the
5. Place the FDD on the metal plate. There are four small screws,
6. Place the support bracket against the slim CD-ROM drive. It
7. Attach the support bracket to the slim CD-ROM drive by tighten-
8. Insert the FDD assembly into the shielding case. Then insert the
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
drive to the metal shielding case. There is also a slim CD-ROM
support bracket which is attached to the shielding case. There are
two screws ("A") on the metal plate. Unscrew these two screws.
(See Fig. 4-5.)
it from the two lugs of the shielding case.
panel PC, and remove it.
two on each side of the metal plate. Tighten these screws.
should fit neatly into the space allocated for the bracket. (See Fig.
4-5.)
ing the two small screws located in the bracket.
slim CD-ROM drive assembly into the shielding case. Make sure
that the hooked lug on the slim CD-ROM drive assembly engages
into the corresponding slot of the combined FDD assembly and
shielding case.
Chapter 4 Hardware Installation and Upgrading
41