Chapter 2 Preparation; Wiring; Inserting An Sd Memory Card - Mitsubishi Electric MELSEC iQ-R Series Introduction Manual

System recorder

Hide thumbs Also See for MELSEC iQ-R Series:

Table of Contents

PREPARATION

2.1

The following shows the wiring described in this document.

Connect the personal computer, CPU module, recorder module, network camera, general-purpose personal computer

(Windows10), and GOT to the PoE switching hub using Ethernet cable.

switching hub

GOT

For the programmable controller, network camera, general-purpose personal computer (Windows10),

personal computer for setting, and GOT, set the IP addresses. The IP addresses must be in the same

segment.

2.2

Insert SD memory cards to the CPU module and recorder module.

Inserting an SD memory card to the CPU module is not necessary. However, the lifetime of the CPU module is shortened due

to the limited number of writing if the save destination of event logging is ROM. Therefore, inserting an SD memory card is

recommended.

The SD memory card in the recorder module is required for saving recording files.

CPU module

2 PREPARATION

2.1 Wiring

Programmable controller

PoE

General-purpose personal

computer (Windows10)

Network camera

Personal computer

for setting

Recorder module

Table of Contents