Xerox Phaser 6180MFP User Manual page 207

Symptom
Partial blanks, creased
paper, or blotted
printing
Vertical blanks
Slanted printing
Horizontal bands,
approximately 22 mm
wide, appear vertically
every 73 mm
Colors are blurry or
there is white area
around objects
Reason/Action
The paper is damp.
Replace the paper.
The paper is outside the recommended specification range.
Replace the paper with a recommended size and type. See
on page 5-6.
The transfer unit, or fuser, is not installed correctly.
Reinstall the transfer unit and/or fuser.
The print cartridges are not Xerox print cartridges.
Verify that the print cartridges (C/M/Y/K) are genuine Xerox cartridges,
and replace if necessary.
Condensation inside the printer causes partial blanks or creased paper.
Turn the printer on, and leave it on, for at least one hour to get rid of the
condensation. If the problems still occurs, go to the Xerox Support website,
www.xerox.com/office/6180MFPsupport, for assistance.
The laser is being blocked.
Remove the print cartridges and clean all debris from the laser len(s) with
a lint free cloth.
The transfer unit, or fuser, is old or damaged.
Check the condition of the transfer unit and fuser, and replace as
necessary.
The print cartridges are not Xerox print cartridges.
Check the condition of the print cartridge, and replace as necessary.
Verify that the print cartridges (C/M/Y/K) are genuine Xerox cartridges,
and replace if necessary.
The paper guides in Tray 2, Tray 3, or Tray 1 (MPT) are not set correctly.
Reset the paper guides in Tray 2, Tray 3, or Tray 1 (MPT). See
Paper in Trays 2 and 3 on page 5-13.
The print cartridge has been exposed to too much light; possibly from
leaving the front door open too long.
Replace the print cartridge.
Color to color alignment is not correct
Use the automatic color registration. See
page 10-25.
Phaser® 6180MFP Multifunction Printer
10-23
Print Quality
About Paper
Loading
Color Registration on