Printer Connection - Ametek BROOKFIELD RST Operating Instructions Manual

1.3.6.4 Thermosel Temperature Control Device
An assembled Thermosel temperature control device is shown on an RST-SST Rheometer in
Figure I-13:
The Thermosel temperature control device (PN: HT RS DIN 81) allows for controlled temperature
experiments up to +300°C with coaxial cylinder measuring system using DIN 81 spindle.
1.3.6.5 Circulating Temperature Baths
Brookfield TC Series Bath with AP Controller and interface cable (part number: RK-36A) allows
direct control of temperature by the RST Rheometer in standalone mode.
Brookfield TC Series Bath with AP or SD Controller can be controlled from a PC running
Rheo3000 software.
AP Controller on TC Series Bath offer maximum performance capability with highest flow rates
of circulating fluid.
MX Controller is adequate for use with KE Cooling Device. SD or AP Controller is recommended
for use with FTKY3, RST Cone Plate Rheometer and ME Measuring Device (Cone Plate Adapter).

1.3.7 Printer Connection

The DYMO LabelWriter® printer (PN: GV-1050) allows for the automatic printing of measurements
taken by the RST Rheometer without PC support. This printer can be connected directly to the
USB Host port of the RST Rheometer. Use the "Report" feature when designing a measurement
program in standalone mode to arrange to print measurement data.
In order to connect the DYMO LabelWriter® printer:
1) Turn the RST Rheometer off with the Power button on the back of the instrument.
2) Insert the printer connecting cable into the USB Host socket on the back panel of the RST
AMETEK Brookfield
Figure I-13
Page 21 Manual No. M14-223-B0818