Adjusting Miter Gauge; Changing Sanding Disc - Grizzly G0967 Owner's Manual

Adjusting
Miter Gauge
The miter gauge angle can be adjusted 60° to the
right or the left, keeping angled workpieces accu-
rate. When the miter lock knob is tight, both the
angle of the miter gauge and its position on the
table are secure and will act as a stop to brace
your workpiece against.
To adjust miter gauge:
1. Loosen miter lock knob (see Figure 25),
adjust angle and position, then tighten knob
to secure.
Miter Lock Knob
Figure 25. Location of miter lock knob.
-24-
Changing
Sanding Disc
The G0967 accepts 20" diameter PSA (pressure-
sensitive adhesive) sanding discs. Use the fol-
lowing steps to change the sanding disc when a
sanding disc wears out or your operation requires
a different grit size.
Items Needed
Phillips Head Screwdriver #2 ............................ 1
Hex Wrench 6mm .............................................. 1
Cleaner/Degreaser ............................ As Needed
Disposable Rags ............................... As Needed
Replacement Sanding Disc ............................... 1
Feeler Gauge ⁄ " .............................................. 1
1
16
To change sanding disc:
1. DISCONNECT MACHINE FROM POWER!
2. Remove (3) Phillips head screws and flat
washers shown in Figure 26 to remove disc
guard.
Disc Guard
Figure 26. Location of disc guard and fasteners.
Model G0967 (Mfd. Since 06/23)
Qty
x 3