Table of Contents
Advertisement
4.
Tighten table lock handles.
5.
Check to see if angle indicator points to zero
(see Figure 45).
— If angle indicator does not point to zero,
proceed to Step 6.
— If angle indicator does point to zero, table
tilt is calibrated correctly and no further
adjustment is necessary.
6.
Loosen angle indicator Phillips head screw
(see Figure 45), adjust indicator to zero, then
tighten screw.
Angle
Indicator
Figure 45. Location of angle indicator and
Phillips head screw.
Calibrating 45° Stop Screw
When the 45° stop screw is calibrated correctly,
it allows you to quickly adjust the table tilt to 45°
without referring to the angle scale.
Tools Needed
45° Square ........................................................ 1
Open-End Wrench 13mm .................................. 1
Hex Wrench 6mm .............................................. 1
To calibrate 45° stop screw:
1.
DISCONNECT MACHINE FROM POWER!
-34-
2.
Loosen jam nut on 45° stop screw (see
Figure 46).
3.
Loosen (2) table tilt lock handles and allow
table to rest on 45° stop screw (see Figure 46).
45° Stop
Screw
Figure 46. Location of table tilt lock handles and
4.
Set 45° square on table surface and other
edge against face of disc (see Figure 47).
Qty
Figure 47. Checking 45° stop screw with square.
5.
Adjust 45° stop screw until table is exactly
45° to disc, then tighten jam nut on 45° stop
screw without turning stop screw to secure
setting.
Table Tilt
Lock Handle
(1 of 2)
45° stop screw.
45° Square
Model G0967 (Mfd. Since 06/23)
Advertisement
Table of Contents
