How To Set The Ethernet Speed - Xerox Document Centre 460 Installation And Troubleshooting Manual

How to set the Ethernet Speed

1.
2.
NOTE Auto-Sensing hubs may not arbitrate correctly with the Document
Centre when Auto is selected. If your hubs/concentrators support
the 100BaseT speed it is recommended you select 100MBPS in
Step d below. (Be sure your Ethernet cable is Category 5)
3.
4.
5.
Page 2 - 2
Enter the Tools pathway
a) Press the Access ( ) button.
b) On the keypad enter 1111 or the current password. Press
the Enter button when finished. Press the Go to Tools
button.
c) The Touch Screen will be used for the remainder of the
data entry.
Set or Change the Network Connection Speed.
a) Press the Connectivity and Network Setup button.
b) Press the Physical Media button.
c) Press the Ethernet button.
d) Select the desired network Speed 10MBPS (10
Megabits per second), 100MBPS (100 Megabits per
second) or Auto (AutoSensing).
e) When finished with your changes press Save.
Press the Exit Tools button.
Wait a MINIMUM of 7 minutes for the printer to reset.
a) Obtain a Configuration Report page from your printer
and verify that your settings have been retained.
Connect your Document Centre to the network with the
appropriate cabling.
Xerox Document Centre Network Installation & Troubleshooting Guide