Tcp/Ip Troubleshooting - Xerox Document Centre 460 Installation And Troubleshooting Manual

TCP/IP Troubleshooting

Basic TCP/IP Communication Problems
This procedure assumes that the printer is turned on and connected
to a functioning network port with the correct cabling.
NOTE: Your Document Centre now has DHCP, LPR, and NetBIOS over
the IP protocol enabled by default. If your DHCP server will
provide host name, IP address, Gateway address, and Subnet Mask,
the Document Centre TCP/IP information will be configured on
initial boot. This means that if you have configured your DHCP
server with the desired information, you should verify that the
information is correct before you follow any of the procedures in
this TCP/IP Troubleshooting section.
1.
2.
3.
4.
5.
6.
7.
Page 17 - 2
Obtain a Configuration Report page from your printer.
Press the Access ( ) button above the keypad.
A password entry field will appear. On the keypad enter 1111
or the current password then touch the Enter button on the
Touch Screen. The Touch Screen will be used for the
remainder of the data entry.
Press the Go to Tools button.
Press the Systems Settings button, then at the next screen,
press the Configuration Report button and wait for the next
screen.
Press the Print Configuration Report Now button.
Allow a minute for the Report to print.
Xerox Document Centre Network Installation & Troubleshooting Guide