Rightfax Installation For Ftp - Xerox Document Centre 460 Installation And Troubleshooting Manual

RightFAX Installation for FTP

Before You Start
NOTE: Your Document Centre now has DHCP, LPR, and NetBIOS over
the IP protocol enabled by default. If your DHCP server will
provide host name, IP address, Gateway address, and Subnet Mask,
the Document Centre TCP/IP information will be configured on
initial boot.
Your Document Centre and your RightFax server must be
connected to a network which has the TCP/IP protocol enabled.
Additionally, record TCP/IP information such as Hostname,
TCP/IP Address, and Default Gateway for both the RightFax server
and your Document Centre.
It is strongly recommended your RightFax server is assigned a
static IP address. If necessary, refer to the Static (Manual)
TCP/IP Addressing Quick Install Card contained in this card set
to configure your Document Centre in this manner.
Dynamic IP Addressing may be used for the RightFax server
provided the DHCP server has been configured with sufficient lease
time so that the RightFax server normal maintenence and service
down times will not result in a change in TCP/IP address.
An account must be created on the server to which the Document
Centre will FTP the fax documents that has sufficient rights or
permissions to allow the Document Centre to read files, write files,
delete files, and create new directories. Anonymous FTP logins will
not allow these rights. Record the login name, home directory, and
password of this account for use during this procedure.
Proceed to the next section entitled Go to the Document Centre
and...
Page 19 - 2 Xerox Document Centre Network Installation & Troubleshooting Guide