Output - Xerox WorkCentre Pro 90 Quick Reference Manual

Output

Output is used to select the finishing requirements for the job. The options will
depend on the finishing output device available.
Options:
Select Collated for output stacked in sets to match the sequence of the originals.
C
OLLATED
Select Uncollated for output sorted into stacks of individual pages.
U
NCOLLATED
The above output will be delivered in one of the following depending on the output
tray:
W
Available if the CopyCentre/WorkCentre Pro is equipped with the 2000 Sheet
S
TAPLED
Stacker/Stapler. It offers a selection of single or double stapling options. Collated
and uncollated stapled sets will be delivered offset in the finisher.
Depending on your model, the machine will staple 2 - 100 sheets. The 100-sheet
maximum applies to up to 20lb / 75 gsm paper.
P 3-4
AGE
Each copy set will be slightly offset to allow easy separation.
W O
ITH FFSET
The copy sets will not be offset.
O
ITHOUT FFSET
X C C
EROX OPY ENTRE
C65/C75/C90 W C
ORK ENTRE
P 65/75/90 Q R
RO UICK EFERENCE
G
UIDE